How can plastic spraying equipment meet the requirements that customers want?
issuing time ：2019-11-11
There are many plastic spray equipment factories, but their respective spray processing technologies are also different. But in any case, the requirements for the quality of large-scale spraying processing are the same, how can plastic spraying equipment meet the requirements that customers want?
First of all, for large plastic spraying equipment, it is necessary to carefully check whether the conveyor belt is abnormal, and if necessary, eliminate hidden dangers in time to ensure the normal operation of the processing equipment. In addition, you must check the wear of the belt, if you have different degrees of wear, you should pay more attention.
Secondly, when the plastic spraying equipment is being maintained, it is necessary to regularly observe whether the transmission wheel and the passive wheel are abnormally uneven; in the later stage, pay attention to whether there are abnormal textures and scratches and obvious unevenness. The uniformity of large-volume spraying is also a concern. If the spraying is uneven, it can be solved according to the different matching of the processing, because the large-volume spraying process is mainly caused by the evaporation of the solvent, which is easy to cause the surface temperature to drop sharply and cause moisture condensation.
Then, try to check the oil-water separator before the large-scale spraying process and drain the water at the bottom of the separator. For example, due to the uneven evaporation of the solvent and the high humidity of the air, it is possible to try to add an appropriate amount of moisture-proofing agent instead of the diluent to reduce the volatilization speed and prevent uneven spraying.
Of course, in order to avoid the above problems, the plastic coating equipment can be used together with the supporting thinner when the large-volume spraying process is performed, but it is necessary to prevent moisture from being mixed therein, otherwise it may cause adverse consequences. And in the processing of plastic spraying equipment should not be processed in places where the temperature is too low and the humidity is too high.